Logo

U1850 Engine Code Repair

Meaning of U1850 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U1850 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U1850 code is occuring now you should check U1850 repair processes.
Now don't ask yourself; What should you do with U1850 code ?
The solution is here :

U1850 Possible Solution:

U1850 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

U1850 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

1
Fuel And Air Metering

8
Fuel Rail Pressure Sensor Circuit Malfunction

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

0
Reverse Input Circuit

Regarding the U1850 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U1850 OBD-II Diagnostic Network (U) Trouble Code Description

U1850 engine trouble code is about Reverse Input Circuit.

Main reason For U1850 Code

The reason of U1850 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

Parts or components should not be replaced with reference to only a U1850 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.